The four new ribs are taken off of the canoe to finish setting while I remove the smashed ribs that they will be replacing.

There is a lot of wood to remove! Not much left, is there?

And here they are installed. Now I am ready to replace the planking that has been removed.

A long shot of the canoe all closed back up, sanded, and ready for varnishing of the interior. The interior requires a minimum of four coats of varnish, each coat sanded and cleaned of all dust before the next coat is applied. After the varnish is complete the canoe exterior can be prepared for canvassing.

These plastic boxes are great for holding all of the necessary fasteners that could be needed. It never fails that what you think that you will need does not include what you really need.

In order to get the correct angle at the end of the gunnels you have to let the cross, then set a line down the center. Then fiddle around getting it just right.

Next step is to make some new decks. Here is a view of them from the bottom showing the arc at the interior edge.

The decks installed and the last of the ribs being fitted. These can only be fastened after the inside edge is shaped to allow for a taper which brings the outside of the rib closer to the gunnel in order for the outside gunnel to sit flush at the stem end. Sounds more complicated than it actually is.

A view of the canoe with the new gunnels.

Once the gunnels are finished being installed and the last ribs are secure, it is time to prepare and bend the replacement ribs.

Time to make some new rib stock for the repairs of the ends of the ribs.

Then they are cut to approximate size and one end is cut to a taper using a jig sled for the bandsaw. This ensures that every taper is the same.

Next, the rotten rib ends are cut off. This canoe has about 25 that needed attention.

Then the ribs are marked and the same taper is applied to the cut end.

Epoxy is used to glue on the new rib ends. And clamps, lots and lots of clamps.